Cisco 300-110 Value Pack (Frequently Bought Together)

A customer has a centralized wireless deployment with N+1 high availability and few open authentication SSIDs configured. After failover, all APs are broadcasting all SSIDs, but the clients are assigned IP addresses from a different subnet. The WLANs on both WLCs are configured with the same dynamic interfaces. Which feature must be incorporated in the wireless design of the second controller?

• A. AAA Override
• B. VLAN Select
• C. AP Groups
• D. RF Protocol

A customer has multiple WLCs running in N+1 redundancy with APs load balanced between the WLCs. The customer performs AP failover testing between the WLCs and notices that some of the APs do not move back to their primary WLC after it recovers. What are two points that must be addressed in the design? (Choose two.)

• A. APs do not have their primary WLC information configured correctly.
• B. DHCP Option 43 information is incorrect.
• C. APs failover priorities are set to Low.
• D. APs do not have their secondary WLC information configured correctly.
• E. AP Fallback is not enabled on one of the WLCs.

A company is upgrading its wireless infrastructure and is in a state of transition. Some parts of the company's building still run on the legacy WLC. The new WLC is not located at the same site as the legacy WLC. The company requires seamless client inter-controller roaming between the new WLC and the legacy WLC, with no disruptions. Both WLCs are separated by firewalls. Which troubleshooting command validates that the mobility control packets between the WLCs can be sent and received?

• A. debug mobility config enable
• B. mapping mobility_peer_management IP address
• C. debug mobility handoff enable
• D. mapping mobility_peer IP address

An engineer configured the optimized client roaming on Cisco WLC with an RSSI threshold of -72 dBm. Clients report frequent disconnections. What must be configured for the AP to guide the client to a better AP?

• A. Enable BSS transition on the SSID and optimized roaming at the radio level.
• B. Disable optimized roaming and enable 802.11v support on the SSID.
• C. Enable BSS transition at the radio level and optimized roaming on the SSID.
• D. Disable coverage hole detection on the SSID and enable BSS transition on the SSID.

A school deploys a Cisco wireless infrastructure in its classrooms to support a high density of mobile devices. The network administrator wants to bond channels in groups of two and only allow APs to send 802.11 management frames at 24 Mbps. What should be included in the design to accomplish this objective?

• A. Set the channel width for 802.11b to 40 MHz and set data rates to 24 Mbps and Supported.
• B. Set the channel width for 802.11a to 40 MHz and set data rates to 24 Mbps and Mandatory.
• C. Set the channel width for 802.11b to 40 MHz and set data rates to 24 Mbps and Mandatory.
• D. Set the channel width for 802.11a to 40 MHz and set data rates to 24 Mbps and Supported.