[2023] Use Valid 5V0-42.21 Exam - Actual Exam Question & Answer
Test Engine to Practice 5V0-42.21 Test Questions
To pass the VMware 5V0-42.21 exam, candidates need to have a good understanding of networking and virtualization technologies, as well as the ability to apply this knowledge to design and deploy SD-WAN solutions. Candidates are expected to have hands-on experience with SD-WAN technologies and be able to troubleshoot common issues that arise in SD-WAN deployments. VMware offers a variety of training and certification programs to help candidates prepare for the exam and enhance their SD-WAN skills.
VMware SD-WAN Design and Deploy Skills certification exam is intended for professionals who have experience in designing, deploying, and managing VMware SD-WAN solutions. VMware SD-WAN Design and Deploy Skills certification exam validates the skills and knowledge required to design and deploy VMware SD-WAN solutions. It also tests the ability to troubleshoot and optimize VMware SD-WAN solutions.
NEW QUESTION # 20
Due to very strict security policies an enterprise customer is looking for an on-premises deployment of the VMware SD-WAN Orchestrator and Controllers. Customer data is not expected to flow through this Controller, however it is desirable that management plane traffic towards the Orchestrator coming from VMware SD-WAN Edges can take the overlay tunnels through this controls.
What are some of the needed steps to achieve the requirements above?
- A. Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plant- and Partner Gateway role and add a static default route with NAT hand off settings under Partner Gateway advanced hand oft settings
- B. Under gateway configuration -> Configure the Gateway roles as Control-Plane, enable Data Plane and Partner Gateway role and add static host mules with NAT hand off settings pointing to the Orchestrator IPs under Partner Gateway advanced hand off settings
- C. Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and enable management plane forward
- D. Under gateway configuration -> Configure the Gateway roles as Control Plane, disable Data Plane and add static host routes with NAT hand off settings porting to the Orchestrator IPs under Partner Gateway advanced hand off settings
Answer: B
NEW QUESTION # 21
A customer is using hypervisor to install VMware Partner Gateways.
Which two hypervisors may be used? (Choose two.)
- A. KVM
- B. XenServer
- C. Kubermetes
- D. Hyper-V
- E. ESXi
Answer: A,D
NEW QUESTION # 22
Which VMware SD-WAN component Is responsible for overlay route distribution?
- A. VMware SD-WAN Edge
- B. VMware SD-WAN Controller
- C. VMware SD-WAN Orchestrator
- D. VMware SD-WAN Hub
Answer: B
NEW QUESTION # 23
A MSP partner needs to setup a Partner Gateway and configure the Handoff Interlace.
Which are the valid configuration options for the Tag type?
- A. None, 802 1q, 802 3ad, and QinQ(0x8100) / QinQ(0x9100)
- B. None, 802 1q. 802_1ac, and Qin(0x8100) / QinQ(0x9100)
- C. None. 802. 1q. 802, 1 ad, arid QinQ(0x8100) / QinQ(0x9100)
- D. None, 802 1d, 802.1ad, and QinQ(0x8100)/ QinQ(0x9100)
Answer: C
NEW QUESTION # 24
A technician at a customer site is deploying VMware SD-WAN Edge 620 notices that the Edge LED is shown amber.
What is the meaning of this LED color?
- A. DNS is not reachable from the Edge.
- B. Edge is still booting.
- C. Internet is not available from the Edge
- D. Edge is not activated.
Answer: C
NEW QUESTION # 25
Refer to the exhibit.
Which VMware SD-WAN Edge High Availability deployment is being used"?
- A. Fault Domain HA
- B. Standard HA
- C. Enhanced HA
- D. VRRP HA
Answer: D
NEW QUESTION # 26
An administrator has been receiving complaints about their SaaS business collaboration apps.
Which network service should the administrator use to resolve the issue?
- A. Direct
- B. CoS mapping
- C. Backhaul
- D. Multi-Path
Answer: A
NEW QUESTION # 27
Refer to the exhibit.
An MSP is designing a solution for a merger of Customer A and Customer B to Customer A's enterprise. Due to overlapping IP addresses and security requirements, the segments with the same names between Customer A and Customer A cannot be merged.
Based on the graphic and the requirements, how many new segments need to be configured in the VMware SD-WAN Orchestrator?
- A. 2 segments
- B. 5 segments
- C. 6 segments
- D. 4 segments
Answer: B
NEW QUESTION # 28
What are three key benefits of VMware SD-WAN? (Choose three )
- A. Automated configuration of cloud resources
- B. Remove requirement of Edge devices
- C. Provision Edges in minutes
- D. Gain visibility across any link
- E. Reduce the burden on MPLS
- F. Layer 2 VPNs between sites
Answer: A,B,E
NEW QUESTION # 29
Which form factor can a customer use to deploy VMware SD WAN Edge?
- A. Open Virtualization Appliance
- B. Docker Container
- C. Oracle Virtual Box
- D. Hyper-V Virtual Machine
Answer: A
NEW QUESTION # 30
A network architect from a service provider is designing an architecture using a VMware SD-WAN Partner Gateway handoff.
Which dynamic routing protocol should the engineering choose?
- A. RIP Version 2
- B. OSPF
- C. Static
- D. BGP
Answer: A
NEW QUESTION # 31
The VMware SD-WAN solution is comprised of Orchestrator, Gateway, and Edge. The architecture ensures separation and secure communication between the management, control, and data plane of the solution.
The management plane consists of the VMware SD-WAN Orchestrator, and the control plane is comprised of the VMware SO-WAN Gateway/ Controller. Which statement correctly describes this situation?
- A. VMware SD-WAN Edges/Gateways establishes a Transport Layer Security (TLS) 1 2 encrypted session to the VMware SU-WAN Orchestrator
- B. There is impact on data plane when the Edge loses connectivity to the management plane. The operator only loses the visibility of the Edge from Orchestrator and cannot make configuration changes on the Edge until the management plane connectivity is resumed.
- C. To make the entire solution to work property, TCP port 443 and HOP port 500 and UDP port 4500 are required to open in the firewall rule, if Edge is deployed behind a Firewall.
- D. Traffic between VMware SD-WAN Edges and from VMware SD-WAN Edges to VMware SD-WAN Gateways uses VMware SD-WAN Management Protocol (VCMP) tunneling over User Datagram Protocol (UDP) port 2427. secured with Internet Protocol Security (IPSec)
Answer: D
NEW QUESTION # 32
During a security-related discussion, an administrator determines that guest users not be able to access any resources on the corporate network.
Which VMware SD-WAN feature can achieve this goal in the most scalable and manageable way?
- A. Segments
- B. Firewall
- C. Business Policy
- D. VLANs
Answer: A
NEW QUESTION # 33
A network administrator is concerned about an Edge that may be approaching its documented limit for the number of simultaneous tunnels. The historical data showing the number of simultaneous tunnels over the time needs to be checked.
Where can this historical data be found?
- A. Use the SNMP manage poll the vcelHealthObject tree in the VELOCLOUD-EDGE-MIB
- B. In the Remote Diagnostics section of the UI, run the ''Total Counts dump'' test.
- C. In the Monitoring section for the Edge in question, navigate to the ''System'' tab.
- D. Connect to the Edge CLI via SSH, and /opt/vc/bin/debug-py- tunnel_count
Answer: A
NEW QUESTION # 34
Refer to the exhibit.
An MSP is designing a solution for a merger of Customer A and Customer B to Customer A's enterprise. Due to overlapping IP addresses and security requirements, the segments with the same names between Customer A and Customer A cannot be merged.
Based on the graphic and the requirements, how many new segments need to be configured in the VMware SD-WAN Orchestrator?
- A. 2 segments
- B. 5 segments
- C. 6 segments
- D. 4 segments
Answer: B
NEW QUESTION # 35
A customer would like to ensure that the traffic towards the Partner Gateway does not exceed a certain bandwidth.
Which feature should be used?
- A. Modify the SD WAN Traffic Class and Weight Mapping
- B. Enable the rate limit under a new custom Business Policy Rule.
- C. Enable the SD-WAN Overlay Rate-Limit.
- D. Change the application priority to low.
Answer: D
NEW QUESTION # 36
During a VMware SD-WAN design session for a core business application, a customer expressed the following requirements:
* Allow business abstraction so that similar policies can be applied across different hardware types.
* Eliminate the need for the operations team to know the type of physical connectivity or the WAN carrier.
* Maintain SLA for real-time application.
Which design should be taken in terms of Link Steering?
- A. Select Error Correct Before Steering with % definition
- B. Select WAN Link, and then define the DSCP tagging
- C. Deselect Error Correct before Steering Defaults.
- D. Select Transport Group, and then select Preferred option.
Answer: B
NEW QUESTION # 37
Refer to the exhibit.
Which VMware SD-WAN Edge High Availability deployment is being used"?
- A. Fault Domain HA
- B. Standard HA
- C. Enhanced HA
- D. VRRP HA
Answer: D
NEW QUESTION # 38
A technician needs to SSH to it VMware SU-WAN Virtual Edge runningversion 3.3.2. What is the default password?
- A. Password configured in cloud_init
- B. adnim
- C. velocloud
- D. No password required
Answer: A
NEW QUESTION # 39
A service provider needs to ensure that the NOC is notified proactively in the event that an Edge interface loses connectivity to its WAN provider.
Which three methods are available for generating these alerts? (Choose three.)
- A. SNMP Trap
- B. Push notification via the VMware SD WAN mobile app
- C. Slack notification
- D. Text/SMS
- E. Webhook
- F. Dyinq Gasp
Answer: B,D,F
NEW QUESTION # 40
......
5V0-42.21 Actual Questions Answers PDF 100% Cover Real Exam Questions: https://www.practicetorrent.com/5V0-42.21-practice-exam-torrent.html
5V0-42.21 Real Exam Questions Test Engine Dumps Training With 53 Questions: https://drive.google.com/open?id=1klX3L0z1nkCWvp1Wu68AF1O3k3NSOYVr