DEA-5TT1 Practice Exam and Study Guides - Verified By PracticeTorrent Updated 62 Questions
2022 Updated Verified Pass DEA-5TT1 Study Guides & Best Courses
Exam Details
The intermediate-level DEA-5TT1 evaluation carries 60 questions to be tackled within the awarded 90 minutes. The passing mark is 60%. Note that to apply for it, you have to pay an enrollment fee of $230. Also, to register, ensure you come up with a Dell technologies account before proceeding to Pearson VUE, the body that delivers the vendor’s exams.
In case you fail to hit the passing grade on the initial try and want to make another attempt, you will have to count seven days before taking the test again. For a third attempt and any other additional one, two weeks must elapse before another trial. To present your best during the assessment, resources like revision books or guides and training courses will be vital. Read on to learn more about the available options.
Detailed Overview of the Exam Outline
To pass the Dell DEA-5TT1 test successfully, the candidates should gain proficiency in the following topics:
- IP as well as network services;
- Technologies for IP routing in addition to routing protocols;
- IPv4 & v6;
- Network basics;
- Transport layer;
- Switch stacking, EMC campus, Datacenter, as well as modular switch documents.
NEW QUESTION 23
Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?
- A. Start frame delimiter
- B. Preamble
- C. Frame check sequence
- D. Cyclic redundancy check
Answer: B
NEW QUESTION 24
Which formula is used for calculating OSPF interface costs?
- A. Reference bandwidth + interface bandwidth
- B. Reference bandwidth / interface bandwidth
- C. Reference bandwidth - interface bandwidth
- D. Interface bandwidth / reference bandwidth
Answer: D
NEW QUESTION 25
An Ethernet switch receives a frame from a directly connected host. The source MAC address of the frame is not present in the MAC address table for the switch. However, the destination address is present in the MAC address table.
What does the switch do with the frame?
- A. Flushes the destination MAC address and updates the MAC address table in the switch.
- B. Discards the frame on all ports and sends an error message back to the host.
- C. Floods the frame to all ports except for the port the frame originated from to locate the source MAC address.
- D. Adds the source MAC address and port to the MAC address table and forwards the frame.
Answer: D
NEW QUESTION 26
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?
- A. N1700 Series switch and N3500 Series switch
- B. N3500 Series switch and N2000 Series switch
- C. N1700 Series switch and N1500 Series switch
- D. N1500 Series switch and N2000 Series switch
Answer: D
Explanation:
Explanation/Reference: https://www.dell.com/en-us/work/shop/povw/networking-os6
NEW QUESTION 27
Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?
- A. 182.15.23.224
- B. 182.15.25.255
- C. 182.15.25.0
- D. 182.15.26.10
Answer: C
NEW QUESTION 28
What are Network Address Translation (NAT) inside global addresses?
- A. Addresses used by NAT router when sending frames to devices on the local network
- B. Public IP addresses used by the local network to communicate with the Internet
- C. Private IP addresses used by the local network
- D. Pubic addresses used by other networks outside of the local network
Answer: B
NEW QUESTION 29
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?
- A. Switch
- B. Port
- C. NIC
- D. Transceiver
Answer: D
NEW QUESTION 30
When configuring a switch, which CLI mode only supports limited show commands?
- A. Maintenance
- B. EXEC
- C. Configuration
- D. EXEC Privilege
Answer: B
Explanation:
Reference:
https://www.dell.com/support/manuals/us/en/04/poweredge-fx2/dell%20fn%20ioa% 20config_9.8.0.0_pub-v1/cli-modes?guid=guid-aeb7d44d-2413-4da8-b8b9-2f8a26bad435&lang=en-us
NEW QUESTION 31
Which route type is added to the routing table by a routing protocol?
- A. Static
- B. Directly connected
- C. Dynamic
- D. Default route
Answer: C
NEW QUESTION 32
A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch.
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?
- A. Switch checks its routing table and forwards the packet accordingly.
- B. Switch duplicates the packet and sends it to all interfaces.
- C. Switch drops the packet.
- D. Switch replies back to the source with an ICMP Reject packet.
Answer: A
NEW QUESTION 33
What accurately describes IPv6 addressing?
- A. IPv6 uses 128 hexadecimal numbers instead of the 32 hexadecimal numbers used by IPv4.
- B. IPv6 addresses are denoted by eight groups of four hexadecimal numbers.
- C. IPv6 uses broadcast addresses for neighbor discovery.
- D. IPv6 is used to converse IP addresses and utilize private addresses.
Answer: B
Explanation:
Reference:
https://en.wikipedia.org/wiki/IPv6_address#:~:text=An%20IPv6%20address%20is% 20represented,0000%3A8a2e%3A0370%3A7334\
NEW QUESTION 34
Which Border Gateway Protocol (BGP) version supports IPv6?
- A. BGPv3
- B. BGPng
- C. BGPv2
- D. BGPv4
Answer: D
Explanation:
Explanation/Reference:
NEW QUESTION 35
What accurately describes the comparison between stacking and VLT?
- A. Stacked switches share a common control plane while VLT peers maintain their own control plane.
- B. Stacked switches and VLT peers allow "single pane of glass" management by maintaining a single control plane.
- C. VLT allows for more physical devices to appear as one virtual device than stacking does.
- D. Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same.
Answer: A
Explanation:
Reference:
https://downloads.dell.com/manuals/common/dellemcnetworking_stacking_vs_vlt.pdf Introduction section
NEW QUESTION 36
Which fields are mandatory TLVs in a LLDP PDU frame?
- A. Chassis ID, Port ID, and Time-to-Live
- B. System Capabilities and Management Address
- C. IP Address, Default Gateway, and DNS
- D. Port Description, System Name, and System Description
Answer: A
Explanation:
Reference:
https://en.wikipedia.org/wiki/Link_Layer_Discovery_Protocol#:~:text=Each%20LLDP%20frame% 20starts%20with,and%20length%20fields%20are%200
NEW QUESTION 37
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?
- A. 4F:23:AF:4A
- B. 23:AF:4A
- C. 00:C4:4F
- D. 00:C4:4F:23
Answer: C
NEW QUESTION 38
On which OSI layers do standard ACL filters operate?
- A. 4 and 7
- B. 2 and 3
- C. 2 and 7
- D. 3 and 4
Answer: D
NEW QUESTION 39
Which message is sent by a router when TTL expires?
- A. Echo request
- B. Time exceeded
- C. Echo reply
- D. Destination unreachable
Answer: B
NEW QUESTION 40
......
Ultimate Guide to the DEA-5TT1 - Latest Edition Available Now: https://www.practicetorrent.com/DEA-5TT1-practice-exam-torrent.html