Pass Exam With Full Sureness - 200-301 Dumps with 216 Questions
Verified 200-301 dumps Q&As - 100% Pass from PracticeTorrent
NEW QUESTION 60
Refer to the exhibit.
An engineer is tasked with verifying network configuration parameters on a client workstation to report back to the team lead. Drag and drop the node identifiers from the left onto the network parameters on the right.
Answer:
Explanation:
NEW QUESTION 61
Drag and Drop Question
Drag and drop the functions from the left onto the correct network components on the right.
Select and Place:
Answer:
Explanation:
NEW QUESTION 62
Refer to the exhibit.
How does router R1 handle traffic to 192.168.10.16?
- A. It selects the OSPF route because it has the lowest cost.
- B. It selects the RIP route because it has the longest prefix inclusive of the destination address.
- C. It selects the EIGRP route because it has the lowest administrative distance.
- D. It selects the IS-IS route because it has the shortest prefix inclusive of the destination address.
Answer: B
NEW QUESTION 63
Which three describe the reasons large OSPF networks use a hierarchical design? (Choose Three)
- A. to reduce the complexity of router configuration.
- B. to lower costs by replacing routers with distribution layer switches.
- C. to reduce routing overhead
- D. to speed up convergence
- E. to confine network instability to single areas of the network.
- F. to decrease latency by increasing bandwidth.
Answer: C,D,E
NEW QUESTION 64
DRAG DROP
Answer:
Explanation:
NEW QUESTION 65
Refer to the exhibit. If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the packet?
- A. 192.168.14.4
- B. 192.168.15.5
- C. 192.168.12.2
- D. 192.168.13.3
Answer: A
NEW QUESTION 66
Refer to the exhibit.
Which switch in this configuration will be elected as the root bridge?
- A. SW3
- B. SW1
- C. SW4
- D. SW2
Answer: B
NEW QUESTION 67
Which statement correctly compares traditional networks and controller-based networks?
- A. Traditional and controller-based networks abstract policies from device configurations
- B. Only traditional networks offer a centralized control plane
- C. Only controller-based networks decouple the control plane and the data plane Most traditional devices use a distributed architecture, in which each control plane is resided in a networking device. Therefore they need to communicate with each other via messages to work correctly. In contrast to distributed architecture, centralized (or controller-based) architectures centralizes the control of networking devices into one device, called SDN controller
- D. Only traditional networks natively support centralized management
Answer: C
NEW QUESTION 68
When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)
- A. FC00::/7
- B. 2000::/3
- C. FF02::2
- D. 2002::5
- E. FF02::1
Answer: C,E
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipv6/configuration/xe-3s/ipv6-xe-36s-book/ip6-multicast.html
When an interface is configured with IPv6 address, it automatically joins the all nodes (FF02::1) and solicited-node (FF02::1:FFxx:xxxx) multicast groups. The all-node group is used to communicate with all interfaces on the local link, and the solicited-nodes multicast group is required for link-layer address resolution. Routers also join a third multicast group, the all-routers group (FF02::2).
NEW QUESTION 69
How to verify SSH connections was secured?
- A. ssh -v 2 -l admin IP
- B. ssh -l admin IP
- C. ssh -v 1 -l admin IP
Answer: A
NEW QUESTION 70
Refer to the exhibit.
Router R1 Fa0/0 cannot ping router R3 Fa0/1.
Which action must be taken in router R1 to help resolve the configuration issue?
- A. set the default gateway as 20.20.20.2
- B. set the default network as 20.20.20.0/24
- C. configure a static route with Fa0/1 as the egress interface to reach the 20.20.20.0/24 network
- D. configure a static route with 10.10.10.2 as the next hop to reach the 20.20.20.0/24 network
Answer: D
NEW QUESTION 71
What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)
- A. when Carrier Sense Multiple Access/Collision Detection is used
- B. when a collision occurs after the 32nd byte of a frame has been transmitted
- C. when one side of the connection is configured for half-duplex
- D. when the sending device waits 15 seconds before sending the frame again
- E. when the cable length limits are exceeded
Answer: C,E
Explanation:
Explanation
The usual possible causes are full-duplex/half-duplex mismatch, exceeded Ethernet cable length limits, or defective hardware such as incorrect cabling, non-compliant number of hubs in the network, or a bad NIC.
NEW QUESTION 72
Drag and drop the Cisco Wireless LAN Controller security settings from the left onto the correct security mechanism categories on the right.
Answer:
Explanation:
NEW QUESTION 73
Drag and drop the DHCP snooping terms from the left onto the descriptions on the right.
Answer:
Explanation:
NEW QUESTION 74
What are two reasons that duplex mismatches can be difficult to diagnose? (Choose two.)
- A. The symptoms of a duplex mismatch may be intermittent.
- B. 1-Gbps interfaces are full-duplex by default.
- C. Full-duplex interfaces use CSMA/CD logic, so mismatches may be disguised by collisions.
- D. The interface displays a connected (up/up) state even when the duplex settings are mismatched.
- E. Autonegotiation is disabled.
Answer: A,D
NEW QUESTION 75
Refer to the exhibit.
Router R2 is configured with multiple routes to reach network 10 1.1 0/24 from router R1. What protocol is chosen by router R2 to reach the destination network 10.1 1 0/24?
- A. EIGRP
- B. OSPF
- C. eBGP
- D. static
Answer: D
NEW QUESTION 76
......
What's Next Step?
The CCNA certification is of the associate level, so there's enough ground to advance your knowledge and skills. After passing 200-301 exam and obtaining the certificate, you can select advanced-level learning paths that align with your career goals. The most suitable option is always the professional-level certifications, specifically the new CCNP Enterprise. Check out the Cisco webpage to find out more information about the whole career path.
Career Prospects
The individuals who complete the Cisco 200-301 exam will fulfill the requirement for earning the CCNA certification. The specialists with this certificate can get the positions that deal with managing the network security of an enterprise, protecting it from different cyber threats, drawing markup, data validation, device counts, and process records, among others. They can also work with security teams in researching and recommending the latest security techniques. All in all, the professionals with this certification can take up the roles of a Network Administrator, a Network Engineer, and an Information Technology Manager. The average salary outlook for the certificate holders is $79,000 per annum.
200-301 Dumps Full Questions - Exam Study Guide: https://www.practicetorrent.com/200-301-practice-exam-torrent.html
Pass 200-301 Exam in First Attempt Guaranteed 2022 Dumps: https://drive.google.com/open?id=1Astu_ETErIV6OEN99A8pMSyaY4VFhouo